Update on the construction
The remote control for the halogen lamp. The light is split in two controlled, once the screen illumination and the rest of the room. Site created with radio-controlled dimmers Inter Techno. As for which lamps 5 is the transformers are run at the time when dimmed "out of phase" dim (here on / dim start and then stop when the desired brightness is reached, that at some point (so after 10 -15 Dimmdurchläufen) are a few light quite bright and some very dark) can be separated completely with the master switch the transformers from the power, then sync they are again . Better than for the fuse box to run. Of course there would be more elegant solutions for this, but it was too expensive. If you are used to turn when leaving the room, turn off the light switch by Mastercard it is not even more.
means power cable outlets either can be clamped directly to the socket or (the real purpose) to switch between a lighting controller and is PAR lamps for the light show to the other end. To see other 4 outlets are fed from two circuits (one light show and even balance to avoid hum), the antenna connection and the network cable and speaker terminals for the Power Amplifier. The halogen lamps get their power also consists of a dedicated circuit. If that be finished by the equipment rack in front of the wall connections and you'll see that there also nothing more ...
The heating of course, had also can be matched.
So, now needs to
- The carpet will be laid on the ground
- A platform to be built in front of the screen to connect the speakers to accommodate
- The screen will be set up
- The projector can be suspended
- The light show will be installed
more.
The heating of course, had also can be matched.
So, now needs to
- The carpet will be laid on the ground
- A platform to be built in front of the screen to connect the speakers to accommodate
- The screen will be set up
- The projector can be suspended
- The light show will be installed
more.